1959 MORRIS MINI FLECK FRONT SEAT KIT Saloon 1973 on These will all have probably

These will all have probably disintgrated by now and will need to be completely replaced

Please note these are only suitable for seats that used the separate raised side bolster design and not seats that were made with a single moulded flatter base foam

Newton Commercial Part No - TK7405 TK7413

The main flat piece has a slit half way up which will allow a calico flap from the seat cover to be pulled through to be attached to the frame

1959 MORRIS MINI FLECK FRONT SEAT KIT Saloon 1973 on These will all have probablyIn the early years of production manufacture was shared between two factories. While mechanically the same, the Austin Seven and Morris Mini used their own trim designs and these designs varied throughout these years until trim became more standardised after 1962. This design was used exclusively in early Morris production, and fits the post leg front seat frames (as pictured below). We believe that this trim was only used up until the middle of