Hybrid Racing K-Series Swap Ground Kit fseries This knob is machined from

This knob is machined from Delrin

and four holes must be drilled in the center tunnel for the other two bolts (no drilling is required if you are replacing a Karcepts shifter adapter plate)

Shift knob height raised from 35mm to 60mm over OEM

You will have to remove and separate the transmission case to change the third spring

Hybrid Racing K-Series Swap Ground Kit fseries This knob is machined fromPRODUCT DETAILS Often when doing a K Swap, the original grounds don't reach or require cutting and splicing to get everything connected. Hybrid Racing's K Swap Ground Kit is a cost effective way to be sure that you will not run into any problems that may be caused by improperly grounded components and make a quick and easy solution to getting your K Swap grounded. Good ground connections are arguably the most important part of any electrical system.